Writing std Applications

If you want to learn how to develop std application, see the following training materials developed alongside Ferrous Systems:

• The book Embedded Rust on Espressif
• The repository std-training

The training is based on ESP32-C3-DevKit-RUST-1. You can use any other Espressif development board, but code changes and configuration changes might be needed.

The training is split into two parts:

• Introductory level examples:
  • A basic hardware-check
  • An HTTP Client
  • An HTTP Server
  • An MQTT Client
• Advanced level examples:
  • Low-level GPIO
  • Interrupts in General
  • I2C Driver
  • I2C Sensor Reading
  • GPIO/Button Interrupts
  • Driving an RGB LED

⚠️ Note: There are several examples covering the use of specific peripherals under the examples' folder of esp-idf-hal. I.e. esp-idf-hal/examples.