Struct eth_phy_config_t 

#[repr(C)]
pub struct eth_phy_config_t {
    pub phy_addr: i32,
    pub reset_timeout_ms: u32,
    pub autonego_timeout_ms: u32,
    pub reset_gpio_num: c_int,
    pub hw_reset_assert_time_us: i32,
    pub post_hw_reset_delay_ms: i32,
}

@brief Ethernet PHY configuration

Fields

phy_addr: i32

< PHY address, set -1 to enable PHY address detection at initialization stage

reset_timeout_ms: u32

< Reset timeout value (Unit: ms)

autonego_timeout_ms: u32

< Auto-negotiation timeout value (Unit: ms)

reset_gpio_num: c_int

< Reset GPIO number, -1 means no hardware reset

hw_reset_assert_time_us: i32

< Time the reset pin is asserted (Unit: us), 0 to use chip specific default

post_hw_reset_delay_ms: i32

< Time to wait after the HW reset (Unit: ms), 0 to use chip specific default, -1 means no wait

Trait Implementations

impl Clone for eth_phy_config_t

fn clone(&self) -> eth_phy_config_t

Returns a duplicate of the value.

fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl Debug for eth_phy_config_t

fn fmt(&self, f: &mut Formatter<'_>) -> Result

Formats the value using the given formatter.

impl Default for eth_phy_config_t

fn default() -> eth_phy_config_t

Returns the “default value” for a type.

impl Copy for eth_phy_config_t